Please follow the step by step instructions below.
Place your keg into a large bucket filled with ice and water and leave to cool for 2-3 hours ensuring the ice is always topped up and cold. This is designed to chill your beer to the correct temperature for the perfect pint every time.
Place the coupler (bottom of the party pump) into the fitting on the keg shown and twist so the party pump is locked into place. If your keg coupler does not require you to twist but requires you to slide on, then simply slide on and clamp down. Once the party pump is locked into place, push the lever down to clamp the party pump into your keg.NOTE: Do not lean over the keg or pump at any time whilst clamping your party pump in.
When initially pouring from the keg it will be under pressure and dispense fast. Make sure the keg is cold and pour off the initial foam and carry on pouring pints until the flow begins to diminish. Only then should you begin to pump to restore the flow. Now, start pulling and enjoying your perfect pint!CAUTION: OUR KEGS ARE PRE-PRESSURED.
If you need further assistance, please contact our team.