Pub Style Set Up Manual
How to change a Keg
- Turn off the gas from the gas cylinder (Left is open and Right is close).
- Squeeze or lift the keg coupler and rotate to loosen it from the keg.
- Place the new keg into position and reverse step b. So re-connect the keg coupler to the new keg and ensure the handle is down which will allow the beer into the pipes.
- Turn the gas valve back on (you may hear the gas going into the keg, this sound should only be for a few seconds).
- Pour your beer, the first few pints may be froth simply as there will be air in the pipes. Once this has passed the beer will begin to flow as normal.
How to change the Gas cylinder
- Turn off the gas from the gas cylinder (Left is open and Right is close).
- Squeeze or lift the keg coupler to loosen it from the keg, you can detach if you wish but its not always necessary.
- Using a spanner or wrench, loosen the nut which is fitted to the gas cylinder (ensure that the cylinder has been turned off).
- Position the cylinder and screw the nut back onto it. Ensure that the nut is on tight but do not over tighten.
- Connect the keg coupler back onto the keg.
- Turn on the gas from the cylinder
- Pour your beer, the first few pints may be froth simply as there will be air in the pipes. Once this has passed the beer will begin to flow as normal.
Special Information: Do not tamper with any other fitting or component of the Pub Style Set Up.
If you need further assistance, please contact our team.
